피사계 심도 계산기
피사계 심도 계산기를 사용하면 초점 거리, 조리개, 센서 포맷, 피사체 거리의 모든 조합에 대해 전방·후방 초점 한계, 전체 피사계 심도, 과초점 거리를 추정할 수 있습니다. 이 계산기는 풀프레임 및 Canon APS-C 카메라를 사용하는 일상적인 스튜디오 및 제품 촬영을 위한 도구이며, 미터법과 야드파운드법 단위를 모두 지원합니다.
PhotoRobot 피사계 심도 계산기
전방·후방 초점 한계, 전체 DoF, 과초점 거리를 추정합니다.
설정
슬라이더는 일반적인 스튜디오 범위(16–300 mm)를 지원합니다. 더 넓거나 더 긴 렌즈를 사용하시려면 위 입력란에 원하는 값(4–1200 mm)을 직접 입력하십시오.
Measured from the focal-plane mark ⦵ on the camera body, the same reference lens specs use for minimum focus distance. The calculator converts it to the lens-to-subject distance (thin-lens equation), and near/far limits are shown from the sensor mark too. See the diagram.
Only to show the distance from the front of the lens; it does not change the DoF. Canon RF: 20 mm flange + lens length from the spec sheet (EF: 44 mm). Zoom lenses get longer as you zoom.
결과
표준 얇은 렌즈(thin-lens) DoF 모델: H = f²/(N·c) + f. 회절, 포커스 브리딩, 개별 렌즈 설계의 영향으로 실제 렌즈와는 값이 약간 다를 수 있습니다.
Lens or sensor mark: where do you measure subject distance from?
Sensor mark (S). The ⦵ symbol on the top of the camera body marks the sensor plane. Lens specifications measure the minimum focus distance from it, and it is the easiest point to measure from on a PhotoRobot setup with a tape.
Lens (u). Depth of field formulas need the distance from the lens's optical center to the subject. When you pick Sensor mark, the calculator splits S into u + v with the thin-lens equation 1/u + 1/v = 1/f: u = S/2 · (1 + √(1 − 4f/S)). Near and far limits and the hyperfocal distance are then shown from the sensor mark as well.
The difference matters at product distances: a 105 mm lens at f/16 with the sensor mark 918 mm from the subject gives 4.8 cm of depth of field. Entering the same 918 mm as a distance from the lens would show 6.5 cm, about a third too much.
The conversion assumes a thin lens. Real lenses focus internally and their optical center is not exactly where the diagram shows it, so treat results close to the minimum focus distance (macro) as estimates. A thin lens cannot focus closer than 4 × the focal length from the sensor (1:1). If you measured from the front of the lens, add the sensor mark to front of lens length to get S.
과초점 거리란 무엇이며, 스튜디오 촬영에서 왜 중요할까요?
과초점 거리(H)는 무한대에 있는 피사체를 허용 가능한 수준의 선명도로 유지하면서 렌즈의 초점을 맞출 수 있는 가장 가까운 거리입니다. H에 정확히 초점을 맞추면 피사계 심도는 H/2부터 ∞까지 확장되며, 풍경 사진가들이 전경과 지평선을 모두 선명하게 유지하기 위해 사용하는 방법입니다.
스튜디오 및 제품 촬영에서는 대체로 참고용 지표로 활용됩니다. 피사체 거리가 H보다 훨씬 짧은 경우(일반적으로 이에 해당하며, H는 초점 거리의 제곱에 비례해 커지고 조리개 값에 따라서만 작아집니다) 피사계 심도(DoF)는 피사체를 중심으로 거의 대칭을 이룹니다. 피사체 거리가 H에 가까워지면 원거리 한계가 무한대로 늘어나며, 계산기에는 ∞로 표시됩니다.
제품/주얼리 촬영 실무 팁: 선명해야 하는 가장 앞쪽 디테일에 초점을 맞춘 다음, 위의 “Near limit” / “Far limit” 행(또는 피사계 심도 차트)을 참고하여 나머지 부분이 피사계 심도 안에 들어오는지 확인하십시오.
피사계 심도 관련 추가 자료
PhotoRobot 고객을 위한 피사계 심도 계산 관련 추가 자료는 아래 사용자 매뉴얼을 참고하십시오. PhotoRobot 권장 카메라, 카메라 해상도의 이해, PhotoRobot 스튜디오 조명과 관련된 피사계 심도 정보를 확인하실 수 있습니다.