Kalkulatur tal-Fond tal-Kamp

Użaw il-Kalkulatur tal-Fond tal-Kamp biex tistmaw il-limiti tal-fokus qrib u bogħod, il-fond totali tal-kamp u d-distanza iperfokali għal kwalunkwe kombinazzjoni ta’ tul fokali, apertura, format tas-sensor u distanza mis-suġġett. Il-kalkulatur huwa maħsub għall-fotografija ta’ kuljum fl-istudjo u tal-prodotti b’kameras full-frame u Canon APS-C, b’unitajiet metriċi u imperjali.

Kalkulatur tal-Fond tal-Kamp ta’ PhotoRobot

Istmaw il-limiti tal-fokus qrib u bogħod, id-DoF totali u d-distanza iperfokali.

Issettjar

mm

Il-cursor ikopri l-medda tipika tal-istudjo (16–300 mm). Għal lentijiet usa’ jew itwal, ittajpjaw kwalunkwe valur (4–1200 mm) fil-kamp ta’ hawn fuq.

Apertura f/16
cm
Distance measured from

Measured from the focal-plane mark ⦵ on the camera body, the same reference lens specs use for minimum focus distance. The calculator converts it to the lens-to-subject distance (thin-lens equation), and near/far limits are shown from the sensor mark too. See the diagram.

mm

Only to show the distance from the front of the lens; it does not change the DoF. Canon RF: 20 mm flange + lens length from the spec sheet (EF: 44 mm). Zoom lenses get longer as you zoom.

Riżultati

Fond totali tal-kamp
34 cm
Near limit 86 cm
Far limit 120 cm
In front of subject 14 cm
Behind subject 20 cm
Hyperfocal distance 531 cm
Lens to subject (used in formula) 95 cm
Ċirku tal-konfużjoni 0.030 mm

Mudell standard tad-DoF b’lenti rqiqa: H = f²/(N·c) + f. Il-valuri jistgħu jvarjaw ftit minn lentijiet reali minħabba d-diffrazzjoni, il-focus breathing u d-disinn individwali tal-lenti.

Lens or sensor mark: where do you measure subject distance from?
Two ways to measure subject distance Side view of a camera, lens and product. The orange dimension runs from the focal-plane mark on the camera body, which marks the sensor, to the subject (S). The black dimension runs from the lens's optical center to the subject (u). The gap between sensor and optical center is v, so S equals u plus v. sensor optical center subject S · from the sensor mark v front of lens u · from the lens

Sensor mark (S). The ⦵ symbol on the top of the camera body marks the sensor plane. Lens specifications measure the minimum focus distance from it, and it is the easiest point to measure from on a PhotoRobot setup with a tape.

Lens (u). Depth of field formulas need the distance from the lens's optical center to the subject. When you pick Sensor mark, the calculator splits S into u + v with the thin-lens equation 1/u + 1/v = 1/f: u = S/2 · (1 + √(1 − 4f/S)). Near and far limits and the hyperfocal distance are then shown from the sensor mark as well.

The difference matters at product distances: a 105 mm lens at f/16 with the sensor mark 918 mm from the subject gives 4.8 cm of depth of field. Entering the same 918 mm as a distance from the lens would show 6.5 cm, about a third too much.

The conversion assumes a thin lens. Real lenses focus internally and their optical center is not exactly where the diagram shows it, so treat results close to the minimum focus distance (macro) as estimates. A thin lens cannot focus closer than 4 × the focal length from the sensor (1:1). If you measured from the front of the lens, add the sensor mark to front of lens length to get S.

X’inhi d-distanza iperfokali — u għaliex hija importanti għax-xogħol fl-istudjo?

Id-distanza iperfokali (H) hija l-eqreb distanza li fiha lenti tista’ tiġi enfokata filwaqt li l-oġġetti fl-infinità jibqgħu jidhru ċari b’mod aċċettabbli. Jekk tenfokaw eżattament fuq H, il-fond tal-kamp jestendi minn H/2 sa ∞ — it-tekniċa li jużaw il-fotografi tal-pajsaġġi biex iżommu ċari kemm il-quddiem kif ukoll l-orizzont.

Fil-fotografija tal-istudjo u tal-prodotti, dan huwa l-aktar indikatur: sakemm id-distanza tas-suġġett tkun ferm iżgħar minn H (li normalment tkun hekk — H jikber mal-kwadru tal-lunghezza fokali u jonqos biss mal-apertura), id-DoF jibqa’ kważi simetriku madwar is-suġġett. Meta d-distanza tas-suġġett toqrob lejn H, il-limitu l-bogħod imur sal-infinit u l-kalkulatur juri ∞.

Konklużjoni prattika għax-xogħol fuq prodotti/ġojjelli: iffokaw fuq id-dettall l-aktar quddiemi li teħtieġu ċar u użaw ir-ringieli “Near limit” / “Far limit” hawn fuq (jew id-Depth of Field Chart) biex tikkonfermaw li l-bqija tal-oġġett jidħol fid-DoF.

Riżorsi Addizzjonali dwar il-Fond tal-Field

Għal riżorsi addizzjonali dwar il-kalkolu tal-fond tal-field għall-klijenti ta’ PhotoRobot, irreferu għall-manwali tal-utent li ġejjin. Sibu informazzjoni dwar il-fond tal-field fir-rigward tal-kameras irrakkomandati minn PhotoRobot, il-fehim tar-riżoluzzjoni tal-kamera, u fir-rigward tad-dawl tal-istudjo ta’ PhotoRobot.