Measured from the focal-plane mark ⦵ on the camera body, the same reference lens specs use for minimum focus distance. The calculator converts it to the lens-to-subject distance (thin-lens equation), and near/far limits are shown from the sensor mark too. See the diagram.
มม.
Only to show the distance from the front of the lens; it does not change the DoF.
Canon RF: 20 mm flange + lens length from the spec sheet (EF:
44 mm). Zoom lenses get longer as you zoom.
ผลลัพธ์
ระยะชัดลึกรวม
34 cm
Near86 cm
โฟกัส100 cm
Far120 cm
Camera126 cm
Near limit86 cm
Far limit120 cm
In front of subject14 cm
Behind subject20 cm
Hyperfocal distance531 cm
Lens to subject (used in formula)95 cm
Front of lens to subject—
วงกลมสับสน0.030 mm
แบบจำลองระยะชัดลึกของเลนส์บางมาตรฐาน: H = f²/(N·c) + f ค่าที่ได้อาจแตกต่างจากเลนส์จริงเล็กน้อย เนื่องจากปรากฏการณ์การเลี้ยวเบน โฟกัสบรีธธิง และการออกแบบเลนส์แต่ละรุ่น
Lens or sensor mark: where do you measure subject distance from?
Sensor mark (S). The ⦵ symbol on the top of the camera body marks the
sensor plane. Lens specifications measure the minimum focus distance from it, and it is
the easiest point to measure from on a PhotoRobot setup with a tape.
Lens (u). Depth of field formulas need the distance from the lens's
optical center to the subject. When you pick Sensor mark, the calculator splits
S into u + v with the thin-lens equation 1/u + 1/v = 1/f:
u = S/2 · (1 + √(1 − 4f/S)). Near and far limits
and the hyperfocal distance are then shown from the sensor mark as well.
The difference matters at product distances: a 105 mm lens at f/16 with the sensor mark
918 mm from the subject gives 4.8 cm of depth of field. Entering the same 918 mm as a
distance from the lens would show 6.5 cm, about a third too much.
The conversion assumes a thin lens. Real lenses focus internally and their optical center
is not exactly where the diagram shows it, so treat results close to the minimum focus
distance (macro) as estimates. A thin lens cannot focus closer than 4 × the focal length
from the sensor (1:1). If you measured from the front of the lens, add the sensor mark to
front of lens length to get S.